Oem bios update intel dh55tc TCIBX10H 44T

Oem Bios Intel Dh55Tc TCIBX10H 44T Code Does Not

WinPE issue fixed; this is caused when HPET is enabled at MRC 2.20 Fixed issue where USB Floppy will not be detected when there is no media in the USB Floppy Drive.

Adjusted temperature measurement to correct values for PECI and non-peci processors.

Fixed issue where no video displays with certain PCI VGA card.

BIOS Version 0068 About This Release: July 7, 2009 PRG3110H.86A Integrated Graphics Option ROM Revision: PXE LAN Option ROM Revision: Changed post Logo file to correct resolution.

Oem Bios Intel Dh55Tc TCIBX10H 44T Code Does Not

Fixed issue where microcode does not get updated when flashing BIOS version from 0053 to 0064.

BIOS Version 0066 May 18, 2009 PRG3110H.86A Added delay for six seconds if certain ultrasound PCI card is installed.

BIOS Version 0065 April 21, 2009 PRG3110H.86A Fixed Hardware monitor display issue when using low fan speed fans.

Added support to show option ROM display screen when SCSI or RAID device installed.

IMPORTANT: Due to support for the new LAN chip, BIOS version 0065 or later is required for the following board revisions (AA numbers): D and later D and later E and later E and later BIOS Version 0064 February 12, 2009 PRG3110H.86A.

BIOS Version 0059 October 24, 2008 PRG3110H.86A Added Fixed Disk Boot Sector option under Maintenance Mode.

Fixed system hang issue with certain hard disk drive recovery card.

BIOS Version 0057 September 9, 2008 PRG3110H.86A Fixed BIOS ID display error.

Fixed issue where mix of PS2 and USB keyboard and mouse causes a POST hang from reboot.

Fixed issue where certain PCI security card causes boot failure.

Changed Hardware monitor and Fan control settings when CPU is not PECI supported.

BIOS Version 0053 July 15, 2008 PRG3110H.86A Fixed issue where system will hang after pressing Power Button for 4 seconds while in OS.

BIOS Version 0047 February 27, 2008 PRG3110H.86A Fixed issue where keyboard not found when connecting USB keyboard.

Changed Recovery behavior back to support Recovery from OLD version of BIOS.

Modified CPU Ratio change function to disable C1E when CPU Ratio has been modified by user, also, enable N2 support if CPU supports N2.

SLP20 Variable which OA20 tool create will not delete under post time, this can let OA20 utility display correct status.

Changed Hardware Monitor string from Ambient Temperature to Motherboard Temperature.

Set boot order in IIA to be the same Boot Order as F2 Setup, when user sets Boot Mode to Advanced.

Added Iflash command f to force setup default function support; running Iflash f will restore OemDefault which IIA or ITK created, otherwise will load Factory Default settings.

Oem Bios Update Intel Dh55Tc Tcibx10H 44T